A new methodology for in-flight radiometric calibration of the MIVIS imaging sensor

Main Article Content

M. Gianinetto
G. Lechi

Abstract

Sensor radiometric calibration is of great importance in computing physical values of radiance of the investigated
targets, but often airborne scanners are not equipped with any in-flight radiometric calibration facility. Consequently,
the radiometric calibration or airborne systems usually relies only on pre-flight and vicarious calibration or on
indirect approaches. This paper introduces an experimental approach that makes use of on-board calibration techniques
to perform the radiometric calibration of the CNRs MIVIS (Multispectral Infrared and Visible Imaging
Spectrometer) airborne scanner. This approach relies on the use of an experimental optical test bench originally designed
at Politecnico di Milano University (Italy), called MIVIS Flying Test Bench (MFTB), to perform the first
On-The-Fly (OTF) calibration of the MIVIS reflective spectral bands. The main task of this study is to estimate
how large are the effects introduced by aircraft motion (e.g., e.m. noise or vibrations) and by environment conditions
(e.g., environment temperature) on the radiance values measured by the MIVIS sensor during the fly. This paper
describes the first attempt to perform an On-The-Fly (OTF) calibration of the MIVIS reflective spectral bands
(ranging from 430 nm to 2.500 nm). Analysis of results seems to point out limitations of traditional radiometric calibration
methodology based only on pre-flight approaches, with important implications for data quality assessment.

Article Details

How to Cite
Gianinetto, M. and Lechi, G. (2006) “A new methodology for in-flight radiometric calibration of the MIVIS imaging sensor”, Annals of Geophysics, 49(1). doi: 10.4401/ag-3151.
Section
OLD

Similar Articles

You may also start an advanced similarity search for this article.