Intelligent post processing of seismic events
Main Article Content
Abstract
The Intelligent Monitoring Systern (IMS) currently provides for joint processing of data from six arrays located in Northern and Central Europe. From experience with analyst review of events automatically defined by the IMS, we bave realized that the quality of the automatic event locations can be significantly improved if the event intervals are reprocessed with signal processing pararneters tuned to phases from events in the given region. The tuned processing parameters are obtained from off line analysis of events located in the region of interest. The primary goal of such intelligent post processing is to provide event definitions of a quality that minimizes the need for subsequent manual analysis. The first step in this post processing is to subdivide the arca to be monitored in order to identify sites of interest. Clearly, calibration will be the easiest and potential savings in manpower are the largest for areas of high, recurring seismicity. We bave identified 8 mining sites in Fennoscandia/NW Russia and noted that 65.6% of the events of ML > 2.0 in this region can be associated with one of these sites. This result is based on 1 year and a half of data. The second step is to refine the phase arrival and azimuth estimates using frequency filters and processing parameters that are tuned to the initial event location provided by the IMS. In this study, we have analyzed a set of 52 mining explosions from the Khibiny Massif mining area in the Kola peninsula of Russia. Very accurate locations of these events bave been provided by the seismologists from the Kola Regional Seismology Centre. Using an autoregressive likelihood technique we have been able to estimate onset times to an accuracy (standard deviation) of about 0.05 s for P phases and 0.15 0.20 s for S phases. Using fixed frequency bands, azimuth can be estimated to an accuracy (one standard deviation) of 0.9 degrees for the ARCESS array and 3 4 degrees for the small array recently established near Apatity on the Kola peninsula. The third step in the post processing is a relocation of the event, using refined arrivai times and recomputed azimuths from broad band flk analysis. By introducing region specific travel time corrections, a median error of 1.4 km from the reported location has been obtained. This should be compared to the median error of 10.8 km for the automatie IMS processing for these events. This improvement in location accuracy clearly demonstrates the usefulness of the intelligent post processing approach.
Article Details
How to Cite
Kvaerna, T. and Ringdal, F. (1994) “Intelligent post processing of seismic events”, Annals of Geophysics, 37(3). doi: 10.4401/ag-4209.
Issue
Section
OLD
Open-Access License
No Permission Required
Istituto Nazionale di Geofisica e Vulcanologia applies the Creative Commons Attribution License (CCAL) to all works we publish.
Under the CCAL, authors retain ownership of the copyright for their article, but authors allow anyone to download, reuse, reprint, modify, distribute, so long as the original authors and source are cited. No permission is required from the authors or the publishers.
In most cases, appropriate attribution can be provided by simply citing the original article.
If the item you plan to reuse is not part of a published article (e.g., a featured issue image), then please indicate the originator of the work, and the volume, issue, and date of the journal in which the item appeared. For any reuse or redistribution of a work, you must also make clear the license terms under which the work was published.
This broad license was developed to facilitate open access to, and free use of, original works of all types. Applying this standard license to your own work will ensure your right to make your work freely and openly available. For queries about the license, please contact ann.geophys@ingv.it.