The Earth Lab 5s (ETL3D/5s) seismic sensor. Design and test

Main Article Content

Gioacchino Fertitta
Antonio Costanza
https://orcid.org/0000-0002-0590-0353
Giuseppe D'Anna
https://orcid.org/0000-0002-4642-3901
Domenico Patanè

Abstract

This work presents a new low cost and low power consumption wide-band (5s) three-component seismic sensor, named ETL3D/5s. The sensor is suitable for seismic regional monitoring (local and regional earthquakes), HVSR measurements, seismic microzonation studies and Structural Health Monitoring (SHM) of civil structures. ETL3D/5s includes a set of three 4.5 Hz geophones and an electronic circuit that increases the geophone’s natural period. The sensor exhibits a period of 5 s and a power consumption as low as 75 mW. Changes in ambient temperature have a small effect on the frequency response because a temperature compensation system is also implemented. A small and sturdy cylindrical housing contains the electronic boards and geophones. The housing design was supported by a modal FEM analysis, in order not to affect the frequency response. The chosen materials and parts guarantee protection against atmospheric agents and watertightness (IP68 degree). The sensor noise model, partially confirmed by a field test, predicts a power spectral density of 10 (nm/s)/√Hz at 1Hz.

Article Details

How to Cite
Fertitta, G., Costanza, A., D’Anna, G. and Patanè, D. (2020) “The Earth Lab 5s (ETL3D/5s) seismic sensor. Design and test”, Annals of Geophysics, 63(2), p. DM215. doi: 10.4401/ag-7857.
Section
Data and Methods

Most read articles by the same author(s)

1 2 > >>