CRUST DEVELOPMENT INFERRED FROM NUMERICAL MODELS OF LA V A FLOW AND ITS SURFACE THERMAL MEASUREMENTS
Main Article Content
Abstract
Propagation of a lava flow is governed by slope topography, magma rheology, heat exchange with the atmosphere and the underlying terrain, and the rate of the eruption. Highly viscous crust is formed due to cooling and solidification of the uppermost layer of the flow. We consider here two numerical model problems for lava flows, both based on the fundamental physics of a hot fluid flow: a model problem, where thermal conditions (e.g. temperature and heat flow) at the lava surface are unknown a priori (a direct model problem), and a model problem, where the lava surface conditions are known and determined from observations(an inverse model problem). In both models, the lava viscosity depends on temperature and the volume fraction of crystals. By way of solving the direct model problem, we perform a parametric study of steady state lava flows to investigate the influence of the heat flux, viscosity, and effusion rate on the lava crust development. Numerical experiments show that a lava crust becomes thicker in the case of the nonlinear heat transfer compared to the case of a linear heat flow at the interface of lava with the atmosphere. Also, the crust thickens at lower lava effusion rates, while higher rates result in a rapid lava advection, slower cooling, and development of a thinner crust. Moreover, a lava crust becomes thicker with a higher coefficient of conductive heat transfer, or a higher lava viscosity, or the growth of effective emissivity of the lava surface. By way of solving the inverse model problem, we use an assimilation technique (that is, a method for an optimal combination of a numerical model of lava flows with observations) to propagate the temperature and heat flow, inferred from measurements at the interface between lava and the atmosphere, into the lava flow interior and to analyse the evolving lava crust. Results of thermal data assimilation illustrate that the physical parameters of lava flows, including the thickness of it crust, can be recovered from measured surface thermal data well enough at least for slow effusion rates.
Article Details
How to Cite
Tsepelev, I., Ismail-Zadeh, A., Starodubtseva, Y., Korotkii, A. and Melnik, O. (2019) “CRUST DEVELOPMENT INFERRED FROM NUMERICAL MODELS OF LA V A FLOW AND ITS SURFACE THERMAL MEASUREMENTS”, Annals of Geophysics, 62(2), p. VO226. doi: 10.4401/ag-7745.
Section
Special Issue: MeMoVolc
Open-Access License
No Permission Required
Istituto Nazionale di Geofisica e Vulcanologia applies the Creative Commons Attribution License (CCAL) to all works we publish.
Under the CCAL, authors retain ownership of the copyright for their article, but authors allow anyone to download, reuse, reprint, modify, distribute, so long as the original authors and source are cited. No permission is required from the authors or the publishers.
In most cases, appropriate attribution can be provided by simply citing the original article.
If the item you plan to reuse is not part of a published article (e.g., a featured issue image), then please indicate the originator of the work, and the volume, issue, and date of the journal in which the item appeared. For any reuse or redistribution of a work, you must also make clear the license terms under which the work was published.
This broad license was developed to facilitate open access to, and free use of, original works of all types. Applying this standard license to your own work will ensure your right to make your work freely and openly available. For queries about the license, please contact ann.geophys@ingv.it.